Cincinnerdi Tech Stuff

A mind-numbing read if ever there was one

Posts Tagged ‘configuration

Changing DRAC timeout

leave a comment »

If your DRAC looks like this, you really need to put it back in the server.
Am I alone in finding the DRAC timeout default to be way too short? It seems whenever I connect to a host using Dell’s Remote Access Controller (DRAC*) that it’s re-asking me for credentials way too often.

Not only that, but finding out where to change this default timeout proved illusive until recently when I stumbled upon it. It’s easy to change once you know where to look.

After logging into the DRAC, click on “Remote Access” in the left panel, then the “Configuration” tab, and on the “Services” header. The “Web Server” settings allow you to change the default of 300 seconds (5 minutes) up to 1,920 seconds (32 minutes).

The 3D click sequence, left panel, top tab, tap header

Your mileage may vary, every DRAC version comes with a complete GUI re-design.

* DRAC is the lights-out managment feature for a Dell PowerEdge Server. It is a “must have” option, allowing you to remotely access the server, access the monitor, notify you of errors, and even turn the server off and on.  It’s like having a computer in a computer.

Keywords: Dell, PowerEdge, Servers, DRAC, RAC, 2950, 2950III, 2900, timeout, lights-out, Scott Ledyard

Written by scottledyard

2010, March 1st at 4:38 pm

Westell UltraLine Series3 9100VM configuration tips

with one comment

StartWestellConfigWanting to make changes to the wifi and DNS settings of the new routers that Cincinnati Bell (CB) is routinely installing now, I went about researching and using trial and error. The goal was to implement WPA2 wifi security and OpenDNS at a router level, so as to help clients be a bit more secure.

Overview of high speed modem/router

Near as I can tell, Cincinnati Bell is using its installed fiber in urban locations to offer a high speed internet, combined with television channels via internet, so-called IPTV. Westell has long been a provider of equipment to our local phone company and this device is meant to offer “Advanced, dual-core processing power with Ethernet, MoCA, or VDSL2 WAN interface for fiber-to-the-home and fiber-to-the-curb networks.” (link) These are hunka-chunka, white bricks and I’ll leave it to others to show us what’s actually inside them and perhaps explain their hugeness.

Getting access to advanced settings

As made clear on Westell’s web site their stuff is marketed to ISP’s, not thru retail / wholesale channels. As such, finding a manual is like pulling teeth. I must give credit to others’ posts on for helping me just figure out the interface and that you need to click on menus up top AND on the left.) Read the rest of this entry »

Written by scottledyard

2009, September 19th at 12:49 pm

%d bloggers like this: